MG6028 Magnetron, E2V Vietnam , MG6028 E2V,  E2V magnetron MG6370E

Cửa sổ đầu ra magnetron có thể được làm mát bằng
không khí có áp suất hoặc khí triệt tiêu hồ quang như SF6. Khi nào
cửa sổ đầu ra được làm mát bằng không khí áp suất cao, một luồng
không ít hơn 0,085 m3
/ phút (NTP) vào cửa hút gió tại
cơ sở của phần khởi chạy là bắt buộc. Nếu SF6 được sử dụng,
thì không cần dòng khí để làm mát cửa sổ. Xem chú thích 7.
Làm mát bằng không khí áp suất thấp có thể được yêu cầu cho cực âm
thiết bị đầu cuối.

The data should be read in conjunction with the Magnetron Preamble. ABRIDGED DATA Fast tuned pulse magnetron for linear accelerators. The tuning drive will rapidly tune the tube to any point in the frequency range and has been designed to be driven remotely by a DC power supply (see note 1). Tuning range (see note 2) ............................... 10 MHz Peak output power (nominal) ............................ 5.0 MW Magnet and launching section ..........separate electromagnet and launching section assembly MG6030 Isolator (see note 3) ........ use of an isolator is recommended Output ........................................................ no. 10 waveguide (72.14 x 34.04 mm internal) Cooling....................... water and forced-air, or water and SF6 GENERAL DATA Electrical Cathode ....................................................... indirectly heated Heater voltage (see note 4) ............................ 13 V Heater current ................................................. 14 A Heater starting current, peak value, not to be exceeded .................................... 40 A max Cathode pre-heating time (minimum) ............... 6.0 minute Tuner current (see note 5) .............................. 5 A max Tuner coil impedance: at 0 A ........................................................... 6.8  at 5 A (with cooling, see note 6) .................. 8.0  Mechanical Overall dimensions ............................................... see outline Net weight ......................................................... 8 kg approx Mounting position ............................................................. any Accessories Electromagnet/launching section ............................. MG6030 Sidearm radiation absorber ...................................... MG6016 1 F coaxial capacitor (see note 4) .......................... MA997A Cooling The magnetron anode and the electromagnet have integral water jackets. The magnetron requires a water flow of 18 to 27 litres/minute; the pressure drop across the water jacket is 103 kPa maximum. The electromagnet requires a water flow of 4.5 litre/minute at a pressure drop of 14 kPa.